Thought I would give a little update.
I had trouble bending the bottom of the replacement qp with a nice radius like CraigGT37's picture showed. I decided to make a straight 90 degree bend there. I found it is very difficult to get the repo outer wheel well, inner wheel well and trunk drop off to match up with the bend in the quarter panel.
However, I think I am getting pretty close.
For reference, I bent the QP 1" from the bottom using a wiss tool that i have used in the past to bend HVAC ductwork in my home. I had to cut the QP at the corner to get the bend to work.
|