Somebody gets to keep a trophy! screwhole is not an issue...but DECK THICKNESS is. Yeah SOMONE can weld that!!!! Finding that someone....might be a bit more challenging. If it's NOT a "special" number block...the SHOP should be able to replace it in a couple phone calls. If it IS SPECIAL.....The shop is going to have to make ALOT of phone calls when THEY REPLACE IT!
Looks like they lost an insert on the cutter head. NOTE: nice FLAT touchoff mark on lifter side.....then progressively deep DIVE at the same "arc". If the insert was loose and tried to come out during the interrupted cut (cylinder bore)...I could see that happening. And immediately making a phone call to REPLACE YOUR BLOCK!
|