Quote:
Originally Posted by Tom Vaught
A lot of different knowledge levels out there. Congrats on a very nicely engineered fixture to drill your block.
Are you using bushings in the outer main caps holes to help locate the center lines of the drills when doing the initial small bit drillings
in the block?
Tom V.
|
I did make a drill guide ‘sleeve’ to fit inside the splayed hole and have the ID be the tap drill for 7/16-14. I was going to use that for if I had to use my bridgeport with the head tipped. Now that im doing it in the cnc. Im not sure if I am going to use it or not because I am planning on installing the caps on dowels with block set on the 18* fixture side. Then tramming center zero in cap and spot facing, center drill, tap drill then tap.