Dave Bisschop intake dyno testing....
474ci engine / 290cfm CNC ported KRE D-port heads with 10.2 to 1 compression on 91 octane fuel with a 236/245 duration hyd. roller cam.
Intakes gasket matched to a 1233 Felpro gasket, each intake was mocked up to make sure port alignment was correct and each intake had the water crossover removed.
Stock iron factory intake with Q-jet carb.
515hp @ 52-5300rpm and 575 lb/ft @ 4000 rpm.
Factory cast iron with the CNC machined plenum with Q-jet carb.
527hp @ 5300rpm and 579 lb ft @ 4100rpm.
Edelbrock Performer RPM
541hp @ 5400 rpm and 591 lb ft @ 4000 rpm.
"The purpose of this test was to see how each intake behaved in this particular engine combination. Other combo's can and will have different results but I felt this info would be interesting to our customers to look at and may be helpful in parts selection"
Dave Bisschop
.
__________________
'70 TA / 505 cid / same engine but revised ( previous best 10.63 at 127.05 )
Old information here:
http://www.hotrod.com/articles/0712p...tiac-trans-am/
Sponsor of the world's fastest Pontiac powered Ford Fairmont (engine)
5.14 at 140 mph (1/8 mile) , true 10.5 tire, stock type suspension
https://www.youtube.com/watch?v=qDoJnIP3HgE
|