Sooooooooooo.........
I called Jesel and had a discussion with the folks in the Custom Shop.
They will make me a custom bronze bushing if needed, but not a custom diameter lifter.
So that's out.... Nice dream, but shot too S--T.
Didn't check for taper or out of round because I used a camera to get the best view I could of the inside of the bore and what didn't I find????????
The oil restrictors. So I guess my mind is made up for me and I have to get this short block disassembled. So back to the engine builder it goes....After I have a discussion with him this week.
Stay tuned.
|