Quote:
Originally Posted by GT182
You must use the solid Brown wire and the Purple wire only. That's all, nothing else is cut or unhooked from the switch. Just use a short piece of wire close to the same gauge and 2 scotch locks.
|
This has been on my 'to-do' list for quite a while, but it has been pretty low on my list as I am not thrilled about cutting things up.
You mentioned using scotch locs, this confused me a little as you mentioned using a jumper. Where did you use them and how did you jumper this? Did you use the UR2 scotch locs to basically make a three way (extra wire coming from each scotch loc) on the purple and brown wires, then connect these extra leads together? I'm guessing the switch has spades that the wiring harness plugs into and there is no place to connect a jumper to, correct? I'm sure it will be obvious when I actually dig into it, but a heads up would be reassuring.
BTW, the diagram is a nice touch for future reference.