Quote:
Originally Posted by 25stevem
The rocker ratio would be 1.5 and the push rod lenght stock was 9.130 to 1.935" or so.
Note that the ideal length for the push rod due to geometry changes from milling the heads or block may need to change.
Also a valve job being done can change the length of the push Rods needed.
|
Think you have a typo error here 25stevem. I believe you were trying to post: "the push rod length stock was 9.130" to 9.135" or so."
Sometimes I have to reread my posts 3 times when I am in a hurry with the info.
Tom V.
__________________
"Engineers do stuff for reasons" Tom Vaught
Despite small distractions, there are those who will go Forward, Learning, Sharing Knowledge, Doing what they can to help others move forward.
|