I did try to pull the plastic bar out and make the spring metal protrude a bit. It held the bar out at about 1/4" after that. When floored and released it went back to where it always has been (about 1/8" sticking out from housing). I still don't understand the reason for the initial setting if it only works when floored and bar is pushed all the way to the rear with pedal rod (which does activate the power). I still haven't tested to see if my solenoid clicks yet. I do have power down to the wire for the solenoid to activate. Or as I look at your earlier post pic, is the one tab supposed to be sticking out enough so that it catches the housing on that tab and doesn't go into it any farther?
|