Quote:
Originally Posted by cgeise
BTW - Are you guys planning on running a full data system?? I HIGHLY recomend it.
|
Curt,
In your opinion, what’s the bare minimum we should be monitoring?
The Holley Dominator ECU supports quite a few inputs.
20 high side (+12v) PWM or switched outputs
16 low side (ground) PWM or switched outputs
6 speed inputs (magnetic or hall effect)
30 0-5v sensor inputs
13 Multi-inputs
Each header tube has an EGT bung, there should also be an additional bung installed in the collector and 1 before the T6 flange to monitor back pressure.
I believe we have the following sensors:
2 NTK O2 Sensors
2 3 Bar Map Sensors
2 Air Temp Sensors
2 100PSI transducer
1 Coolent Sensor