| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
06-24-2007, 05:00 AM
|
||||
|
||||
thrust bearing question
I have received a set of crank thrust bearings,Clevite, and both halves have an oil hole in them, is this right? or have they sent 2 tops?
if so, can they still be used or not? thanks Rick. |
|
#2
06-24-2007, 11:57 AM
|
||||
|
||||
Are these full grooved main bearings? If so, that would be right. Instead of them making two different full grooved thrust bearings they just use the same one for both. I have a set of Clevite MS-483G main bearings in my hand that are half groove and they have a solid thrust lower half.
__________________
Paul Carter Carter Cryogenics www.cartercryo.com 520-409-7236 Koerner Racing Engines You killed it, We build it! 520-294-5758 64 GTO, under re-construction, 412 CID, also under construction. 87 S-10 Pickup, 321,000 miles 99Monte Carlo, 293,000 miles 86 Bronco, 218,000 miles |
|
#3
06-24-2007, 12:58 PM
|
||||
|
||||
|
http://www.angelfire.com/fl4/pontiac...earingmod.html
It seems to be needed only with bearings that don't have the scallops running all the way down thru the sides to relieve pressure. |
|
#4
06-24-2007, 01:10 PM
|
||||
|
||||
|
Ken
these are the ones I got from you. can I use them on my Eagle crank? Rick |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
