| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
05-02-2026, 09:13 AM
|
||||
|
||||
1980 TA engine harness
Swapping the 301 out of my 80 TA for a 455. Factory engine harness is cobbled together so looking to replace with new harness.
Question for the guys that have swapped engines will the factory harness reach or since I need to replace the harness should I just go with a 1979. 400 harness?
__________________
65 GTO, Tiger Gold, Nostalgia Super Stock 421, 2-Carter AFB carbs, Stock Suspension, 3550lbs Full Exhaust-- 9.70's@135 66 GTO (Retired race car) 421 CID Multiple NSCA/NMCA World Champion 66 GTO 389 3x2, 4 speed, 3.90 gear, Montero Red 33K original Miles 67 GTO 2dr Post, 428, Tri Power, 3.55 Gears 80 Trans Am Black SE Y84 W72 WS6 |
|
#2
05-02-2026, 10:08 AM
|
|||
|
|||
|
Will the factory harness reach what? The 301 engine is in the same position and uses the same basic accessories as a 400 or 455, the harness should be the same length as other engines use.
For a new harness, I have use American Auto Wire, AAW, very good quality. |
| The Following User Says Thank You to 78w72 For This Useful Post: | ||
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
