[Pzr]

Hi.
Does anyone got information about the holes in the rear fender for the rear wheel spoilers? (the two holes to mount the spoiler in against the rear fender in front of the rear wheel?)
Any measures to drill the 2 holes would be great.
My firebird is not an original t/a so, but i like the appearance and try to get the car into what i like the most!

; Emanuel

[Pzr]

Nobody with advice to give? Maby photos? maby a link...

[Gordy Doyle]

Take a couple peices of a file folder and overlap them in such a way that each peice is over one of the the mounting studs coming out of spoiler. cut out the holes for the studs and push the templates down on the spolier. Once you get both peices of the template laying flat against the spoiler the way you like them, you can tape them together. Trace the outline of the spoiler on the other side, cut it out with scizzors and lay your new template on the dog leg of the rear quarter and drill where your template holes are.
I think the factory holes were about a 1/4" larger then the studs coming through for minor adjustment i guess.
Good Luck
Gordy

[Pzr]

Thanks a lot!
Checked the spoiler (from ci) against the fender and it looked really good! (I had the fiberglassversion earlier but the fitment was wery poor, on one side it didn't fit at all.)
So i'm really positive to getting this looking good.

:Emanuel