| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
|
||||
|
||||
|
Just curious if this might be an original equipment wheel cylinder? I googled the number & didn't find anything. going to rebuild & restore them if they are GM originals. Kinda cool seeing USA stamped on all the seals & casting.
![]() the dust seals fit inside the housing ends, rather than over the outside like most replacements. Thoughts? .
__________________
![]() 68 GTO 4-spd Convertible 78 S/E Trans am L78, WS6 Auto 78 S/E Trans am W72, WS6 Auto 79 10th aniv W72 Trans am 80 Indy pace car Trans am 89 Trans am GTA |
|
#2
|
||||
|
||||
|
Here is a pic of a front wheel cylinder pulled off a 68 Lemans ... could be original. The other side of the same car had an equally old one with Wagner/Lockheed on it, and USA on the reverse side.
I'd guess up until the 80's the aftermarket units were still made in the USA. |
|
#3
|
||||
|
||||
|
originals say
Delco moraine cast into them I have originals if you need them Scott |
|
#4
|
||||
|
||||
|
Can you post a pict if you have them laying nearby? Just curious what they look like as I
am not sure I have ever seen an original. I will probably either rebuild the ones I have or use the ones I bought years back. However they are probably china made, so I would at least like to rebuild USA made units.. Most of the rebuild kits I see though, have the dust boots that fit over the edges of the housing, vs pushing into the ends like the originals had.
__________________
![]() 68 GTO 4-spd Convertible 78 S/E Trans am L78, WS6 Auto 78 S/E Trans am W72, WS6 Auto 79 10th aniv W72 Trans am 80 Indy pace car Trans am 89 Trans am GTA |
|
#5
|
||||
|
||||
|
pictures of original spare rear 7/8 wheel cylinders
Scott |
| Reply |
|
|