 |
|
| Non Pontiac Motors in Pontiacs includes factory 403,305,350 Chevy, Buick V6, Also Pontiac Motors in non-Pontiacs! |
| Reply |
|
|
Thread Tools | Display Modes |
|
#1
07-28-2004, 06:32 AM
|
||||
|
||||
I'm sure this has been asked many times before, but the search feature is not working at all.
Will a Pontiac clutch housing and flywheel bolt directly up to a 350 small block Chevy? If not, is there a kit or do you need to use Chevy parts? Chris
__________________
69 GTO Hardtop project - started without a clue, will finish only by the grace of the PY Forums and Mr. Dave Wrzesinski (magicV8) - candidate for Father-In-Law Of The Century. We are building a bad-ass, hot-looking, hot-running Pontiac street machine. |
|
#2
07-28-2004, 06:32 AM
|
||||
|
||||
|
I'm sure this has been asked many times before, but the search feature is not working at all.
Will a Pontiac clutch housing and flywheel bolt directly up to a 350 small block Chevy? If not, is there a kit or do you need to use Chevy parts? Chris
__________________
69 GTO Hardtop project - started without a clue, will finish only by the grace of the PY Forums and Mr. Dave Wrzesinski (magicV8) - candidate for Father-In-Law Of The Century. We are building a bad-ass, hot-looking, hot-running Pontiac street machine. |
|
#3
07-28-2004, 08:29 AM
|
|||
|
|||
|
no- the bell housing will not bolt up - the pontiac flywheel will not go on a chevy- not sure about the adaptor.
|
|
#4
07-28-2004, 09:25 PM
|
||||
|
||||
|
All the larger Pontiacs had 11" clutches, the only SBC to have them was in trucks. Everything else is different, you wont be able to use anything other than the throwout bearing and the transmission itself.
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
