| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
01-12-2025, 01:20 PM
|
|||
|
|||
1/2 check valve
Hi
I'm thinking about adding a Carter pusher pump near my gas tank to help starting the engine only and I'm looking for a quality 1/2 barb check valve for my rubber fuel line that won't cause too much restriction when running the car at wot. Which product do you recommend to me? Is this product good ? (see picture) Thanks in advance ! Pierre |
|
#2
01-12-2025, 02:06 PM
|
||||
|
||||
|
If you have a mechanical pump you should not need such I set up just to start the motor.
Your likely issue is that the pump is sucking air due to poor connections from rubber fuel line to steel line, or rusted out pin holes in the steel line in between the tank and pump . And yes on the suction side you can have these problems and not see a fuel leak. If you have a carb fuel boiling condition from todays crappy gas then that’s a different story.
__________________
Wernher Von Braun warned before his retirement from NASA back in 1972, that the next world war would be against the ETs! And he was not talking about 1/8 or 1/4 mile ETs! 1) 1940s 100% silver 4 cup tea server set. Two dry rotted 14 x 10 Micky Thompson slicks. 1) un-mailed in gift coupon from a 1972 box of corn flakes. Two pairs of brown leather flip flops, never seen more then 2 mph. Education is what your left with once you forget things! Last edited by steve25; 01-12-2025 at 02:12 PM. |
|
#3
01-13-2025, 10:48 PM
|
|||
|
|||
|
Ok thanks Steve for the reply
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
