Pontiac - Race The next Level

          
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 09-02-2003, 06:24 AM
73LeMans's Avatar
73LeMans 73LeMans is offline
Chief Ponti-yacker
 
Join Date: Mar 2002
Location: Berkley, MA
Posts: 893
Default

So I fired up the motor the other day for the first time, and I tried to time it, but the line on the balancer is bouncing all over the place. I'm not sure why. Any ideas? Let me tell you what I believe to be true, and then you can tell me what I'm overlooking?

• The balancer is a Fluiddamper. It slips on tight, and the key ways are not loose.

• The HEI distributor has been recurved by Larry Rowe and has new bronze distributor gear. The coil is about 3 years old. The cap is about the same. MSD does all of the real work in the dist and there is no module.

• Plug wires are 8mm Taylors in great condition. 3 years old. (less than 500 miles)

• The timing chain is old in age, (6 years) but can’t have but 500 miles on it. It’s a Comp Cam double roller. Been on and off the motor 5 times or so. Installed can straight up.

•The cam is a brand new Comp Cam solid roller. The engine fired right up when we initially started it so I don't think it’s the cam due to lobe/gear/wear, but I never checked the end play on the cam and I also don't have anything spacing out the cam where the fuel pump eccentric used to be. You think this could be it? I never ran the fuel pump eccentric with the old hydraulic Comp cam and never had this problem.

Someone I had spoken to claims the flexplate might be out of round and causing crank vibrations up to the cam… I don't buy it, but I haven’t seen everything…possible? The flexplate is a stock Pontiac one with the 3 holes for the converter slightly enlarged to 7/16ths. (up maybe a 16th from the original hole) Drilled it myself. Could be out of round, but wouldn’t that cause an erratic idle more than it would cause spark timing to be flaky?

I think I covered everything it could be…any thoughts?

Oh yeah…the timing gun is a relatively new Sears dial back gun. Works fine on others cars.

If you think of something, let me know. I’ll be checking back when I get the chance.


Thanks in advance.

Who needs nice and pretty, when you can have mean and nasty? 73 LeMans: 12.5 in the 1/4 on its way to 10.90's!

__________________
.
Mark S
.
Who needs nice and pretty, when you can have mean and nasty?
KRE Aluminum headed 463CID 73 LeMans. Used to run 10.6x @ 124.55. 3700lbs
.
So much for 2020...shootin for 9s in 2021...and in 2022 apparently.....and 2023....and 2024.....and 2025.....who am I kidding? there will be no 9s with this engine!
>>My 73 Build thread
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:23 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017