| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
 |
|
Menu
| The Body Shop TECH General questions that don't fit in any other forum |
|
|
Thread Tools | Display Modes |
|
|
| The Body Shop TECH General questions that don't fit in any other forum |
|
|
Thread Tools | Display Modes |
|
#1
08-07-2002, 02:26 PM
|
|||
|
|||
How much risk is there if both floor pans from the firewall rearward to the start of the rear seat pan are removed for '69 HT.
I purchased full-length pans and already completely removed the LH, but did not notice the lip that runs down the transmission hump and drive shaft length on the pan. The LH pan goes on top of the RH... Question is this... being that I have to replace the RH pan as well as the center brace, how much risk is there of the body twisting if I remove the entire RH pan? I do have 1" tubular steel body braces between the A-pillar and lock post betwen both doors (see my Web page pictures) as well as have the vehicle on jack stands. |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode