| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
08-10-2002, 11:44 AM
|
|||
|
|||
Ok lemme see if I can explain this..I have a heavy 3900lbs car with a 3.42 rear gear a 468 with 6x heads and a victor Dom set up.Car runs 11.9@115 spinning ,I go thru the traps @ 5100RPM.Ok heres the problem,I ordered this converter from PTC 3800 ten inch,It flashes in third gear rollin 10 mph to 3900rpms.I did not tell them about me using a tranny brake but I did tell them about the NOS useage.I have the NOS wired into the trannybrake with a relay.Heres my question,will the trannybrake make the converter not lock up as well on the gas?When I tried it out,the rpms came right up to 6000 and when I shifted they came right up to 6000 and I didnt gain any eighth mile MPH from my motor run.I just unloaded the car and tried to footbrake it and the tires spin @ 2800 in my driveway and it stalls at 3900 against the brake.Any suggestions before I pull it out and ship it back to PTC.
Thanks, Roger I did check the fluid and it is clean and not burnt. [ August 10, 2002, 11:46 AM: Message edited by: Roger C ]
__________________
One Big Ugly 4dr with an attitude.. |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode