[Sinystr79]

Hello all. Nothing too basic? Ok. Here goes. Wanted to change rear bearings and seals. Pulled cover off of rear, went to remove pinion shaft retaining bolt....Snnaap! Got it drilled, tried to use an easy out, but it aint budgin. Afraid easy out going to break off. You know the feeling you get just before that happens. Thats where I'm at. I can bolt cover back on, refill with new fluid, but bearing still going to need replaced. If that easy out snaps, I guess Im looking at replacing the whole rear? I am by no means a gear head, but learning as I go. This forum is a great source of info. Any ideas, suggestions on a fix or replacement is appreciated...Thanks...Scott

------------------