 |
|
| Non Pontiac Motors in Pontiacs includes factory 403,305,350 Chevy, Buick V6, Also Pontiac Motors in non-Pontiacs! |
|
|
Thread Tools | Display Modes |
|
#1
08-21-2006, 11:04 AM
|
||||
|
||||
Another Pontiac powered Chevy truck
I have a 81 3/4 ton 2 wheel drive. I read some of the previous posts on this subject that said you just had to move the mounts up or down 1 hole. I have the trans bolted to a bare block and the mounts are 1 inch behind the holes so I have to slide the mount plates back and redrill the holes. My question is are the 1/2 ton and 3/4 ton frame mounts in the same position?
Thanks, Eric
__________________
Eric 1969 GTO - 461, turbo 400, Continental 13", 3.08 gears. - 12.59 e.t. @ 108.43 mph, 1.898 60' 1978 Oldsmobile Cutlass Supreme- 461, turbo 350, PTC 3500 converter, 9" 3:50 gears. = 11.39 e.t. @ 117.55 mph, 1.599 60' on E85 |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode