| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
04-07-2008, 11:17 PM
|
||||
|
||||
Milling heads
N00b Question('s) here,
How much can a pair of heads be milled without intake fitment problems while at the same time raising the compression. The heads are 70' #11's off of the 400 with an 8.6cr. Its goin on a 70 350 with either an 068 or a comp xe256h,perfromer,(not sure which carb) 2400 stall and either 3.55's or 3.73's. its a 70 lemans conv. and its my first car iv'e ever owned so any other suggestions would be great. But, im sticking with these heads, i know i should get 17's but can't find them and these were already magnafluxed with new everything and best of all FREE*. Thanks Ahead of time, Pat |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode