01-09-2009, 12:13 PM

ironhead68 ironhead68 is offline

Junior Member

Join Date: Nov 2008

Posts: 6

Oversize Thrust Bearing

4-bolt, 455' block with non-matching factory caps. Line honing will cure the bore, but thrust surface misalignment is the problem. Jim Hands book(page 26) mentions overthick thrust bearings. Has anyone used these? Is this the solution? Are they still available? Where? Other expert suggestions or comments...Thanks.

Reply With Quote

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 02:40 PM.

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

Menu

About Us