[65gto69]

Hi Guys,

Being laid off and unemployed for well over a year, I need to start selling some of my Pontiac stuff that I had for future projects but will not get to before I run out of money. So if you can give me an idea of how much this stuff is worth, I can post it here on the PY site for other Pontiac people who might need them.

1) A set of 4 1966 Pontiac rally 1 wheels with centers and after market original rings. This is an original set had them for over 20 years, mounted on tires. Excellent condition but do not know the code because of having tires mounted?

2) 1965 tri-power intake in great shape except when I purchased it someone welded the heat tube areas shut, other than that in really great shape and have used it about 20 years ago. I am missing the front carb due to a fire, but have the center and the rear., and 3 repo chrome air cleaners with paper elements?

3) 1966 tri-power intake, needs to be tanked or blasted, a couple broken studs need to extracted, no carbs, linkage or waterneck, just the intake?

4) 1965 421 WG block with matching arma steel crank. Missing the 4 bolt caps but comes with 2 bolt caps. Bores measure 4.09, crank measure 3.25. Block should be tanked and bored to desired size, crank should be turned has surface rust on the journals?

5) 1968 Pontiac 400 YC motor. This was pulled about 3 years ago and was running when pulled, I replaced with the motor in my signature. This motor was my pride and joy and has great power. Motor has 3.75 stroke arma steel crank, polished 58-62 forged rods, trw 30 over pistons, clevite bearings, crane cam flat hydraulic 495/510 lift, 1968 #16 heads, have been ported and bowled flowed 250 at 600 lift, misplaced sheet, crane springs to match cam, stamp steel 1.65 rockers, polished torker 1 intake, R.A.R.E. 1967 Pontiac HO cast iron headers, chrome tall baffled valve covers, timing cover, water pump, pulleys, dist w/ accel hi-po points, condensor, cap & rotor and accel yellow superstock wires?

6) 1965 power brake booster and master cylinder, removed from car due to new motor, no room between valve covers and booster and not enough vacuum, worked great when pulled 1 year ago?

7) A set of 1974 4X-1H heads, screw in studs, big chamber 455 heads, these need to be redone, was going to use these to build a blower motor with the 421 block, but obviously that is no longer going to happen?

Let me know what you guys think a good listing price for these items would be. I have no idea what price to put on them, I don't want to over price them so they don't sell, but I don't want to under price so I am giving them away. I know this is not the time to sell, but time knows no boundry when bills are due and no money available.

Thanks for your help,
Mark