| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#6
08-18-2009, 12:38 PM
|
||||
|
||||
When I first installed my pypes set I thought that I had the same problem. I found that if you rotate the tail pipe/axle loop(??) even a little bit then the angle of the tail pipe changes alot. Your axle clearence stays basically the same but you get a different angle on the rear section of pipe. I will include some photos of how mine looks.
|
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode