 |
|
| View Poll Results: '70-'73 tailpanel repop demand guage | |||
| I need one and would pay $400 for a correctly done repop. |
   
|
48 | 75.00% |
| I need one but would not pay that much. |
  
|
15 | 23.44% |
| I need one but will not use a repop, regardless or its quality. |
  
|
1 | 1.56% |
| Voters: 64. You may not vote on this poll | |||
|
|
Thread Tools | Display Modes |
|
#31
10-08-2009, 12:56 AM
|
||||
|
||||
No, the problem is that not everyone wants to remove their trunk floor and tank supports just to replace the tail light section which is likely not damaged. If the lower part could be sectioned in, the part most likey in need of replacement would be addressed without the need for major surgery on the back half of the car. If it were me, I would just make a lower skin to start out. That would essentially be a slightly rolled piece of sheet metal with a stamping at the bottom where it meets the inner panel. I could not imagine that running too much more than $100.
__________________
71 Formula 433, Splayed cap 400 block, 4" stroke Scat forged crank, 6.8 Eagle rods, custom Autotec pistons. SD 295 KRE D ports, Old faithful hybrid roller, Torker II, Holley Sniper Stealth, Tribal Tubes, TKO 600, 3.73 Eaton posi. |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode