| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
10-13-2010, 08:31 PM
|
|||
|
|||
Another bench bleeding question...
So once you get your master cylinder bench bled...how are you supposed to remove the bleeders and install your hard lines without getting brake fluid EVERYWHERE? I've dry tested the procedure and the minimum I can remove a bleeder and get the line hooked up is about 20 seconds, and up to a minute if I cant get it threaded immediately. I guess not much air will get back into the thing, but wont it leak all over as I do this? Am I just supposed to put a big towel under it to catch it?
Thanks |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode