| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
10-07-2012, 11:16 AM
|
||||
|
||||
2nd Gen Shaker fit with Holley or tall manifolds
I was working an air cleaner for my Shaker. I have never been happy with my PTFB air cleaner for various reasons. 1) The element provides only 2" of actual filter rather than 3". 2) The distance above the air cleaner base in only 1 3/8". 3) The lid seals against the shaker only providing about a 1/2" slit at the rear for air to enter. IMO, all of these are counterproductive to using a performance intake manifold and Holley to begin with.
My goal was to run a drop base cleaner that will allow a Torker II and spacer. It had to use a full 3" element and had to increase the base to lid distance to at least 2" and preferably more. Here is what I have come up with so far. I need to clean some things up and I think I can make some improvements so I can run a full 1" spacer or RPM but for the most part, what I have accomplishes my goals.     
__________________
71 Formula 433, Splayed cap 400 block, 4" stroke Scat forged crank, 6.8 Eagle rods, custom Autotec pistons. SD 295 KRE D ports, Old faithful hybrid roller, Torker II, Holley Sniper Stealth, Tribal Tubes, TKO 600, 3.73 Eaton posi. |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode