| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
 |
|
Menu
| The Body Shop TECH General questions that don't fit in any other forum |
|
|
Thread Tools | Display Modes |
|
|
| The Body Shop TECH General questions that don't fit in any other forum |
|
|
Thread Tools | Display Modes |
|
#2
08-01-2013, 07:37 PM
|
||||
|
||||
I used 18ga. It seemed to be the same thickness as the rear fenders and wheel wells. 20ga seemed too thin for exterior body panels, but can be used in certain areas where more bends are needed or where it doesn't span without support, etc. Good to have both materials available and use your own judgment.
|
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode