I overlooked the pushrods :(
Went to finish putting my engine together today and adjust the rocker arms and. . . The pushrods are too short. With my poly locks all the way down its just that there's a slight pressure on the rocker arms. I had the block zero decked and 0.015" was removed but I installed screw in studs in the head. I'm having a difficult time finding somebody nearby to borrow an adjustable pushrod. Ugh, this is a bummer of a start to my weekend.
__________________
1967 GTO, 432 (428+.030), 4-bolt mains, factory Nodular crank, scat rods, icon dished pistons, Lunati HR 243/ [email protected], .618/.622 lift, Edelbrock 72cc round port heads, 10.5:1, offy 2-4 intake, Edelbrock 650cfm carbs, Super T10 trans (2.64 first), BOP 10 bolt w/ Eaton posi and 3.36 gears
|
02-14-2014, 06:02 PM
Threaded Mode