[blueghoast]

I got the motor free and turning over good.
First thing I did was drain the oil I used a propane torch to heat the oil pan
to loosen the sludge at the bottom of the pan. Worked pretty good.
Put some fresh oil in it and rolled it over till the gage read good pressure.
Then took some 1000-grit sand paper to the points cleaned a set of plugs
and gave it a shot of either and give it a spin. It didn't start butt it did fire
A bunch of times so I know it will start. I unhooked the fuel line so it
wouldn't pull any thing from the tank until I can address that situation.
When I get time I'll use a gas can to the fuel pump and see how this
thing runs.

GT.