Got ambitious today and finished cleaned / undercoated the rear axle and frame rails, installed a new pinion seal, and adjusted the clutch linkage. Tomorrow is new upper control arms. Sometime next week all new tie rods / drag link / idler arm go on and the new Pypes Violator exhaust gets ordered. Put a new battery in it too so it can crank up and drive around on it's own (love the sound of open headers).
After that... heater core and install two new front fenders and it's off to the body body shop and I"ll let them start their process. I think I can almost see the light at the end of the tunnel....
|
10-18-2014, 07:16 PM
Threaded Mode