| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
02-19-2016, 06:58 PM
|
|||
|
|||
Driveshaft orientation
I'm replacing the slip yoke and u-joints on my '69 4-speed Judge, and I'm wondering if the driveshaft has a front and rear. The u-joints have been replaced before.
It has two different diameters, with a foot-long smaller diameter section at one end, and a 3 or four-inch section at the other end. The factory shop manual and assembly manual don't say anything, or have any good pictures. I can't think of a reason it would matter, but does anyone have any thoughts?
__________________
Lee Peterson ------------- "I didn't expect a kind of Spanish Inquisition...!" '69 Cameo White RA III Judge, 4 speed, owned since 1977 -- my first car. |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode