| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
04-21-2017, 10:19 PM
|
|||
|
|||
conv top dilema
Putting my new top rail seals on my 66 2+2 tonight. Driver side went on and seemed ok. Put on the passenger side and the header end was way too long. So I measured both top seals and they were the same. Then I measured the first section from the front edge to the joint. There is a half inch difference. Is the header bow adjustable where the latches attach?
The other item was that the first rail seal section is longer than the original. Do you cut it on the big rubber end or cut it on the other end and drill new holes ? 
|
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode