FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
||||
|
||||
Power steering return line
During my engine swap the Power Steering Return Line split.
I see I can get a replacement that comes with the pinch clamp, the steel end with the fitting and pinch clamp. In the Ames catalog the picture shows the steel end with a pinch clamp installed. My old line has the pinch clamp on the hard steel side but the other end used a hose clamp. Is a pinch clamp supposed to be used on both ends? I never had a problem, but the 50+ year old finally gave out. If the pinch clamp needs to seated/pinched is there a special tool needed or is this something that can be done with channel locks or something similar?
__________________
I don't always cross thread the bolt - but when I do I run that bitch in with an impact until it's tight! |
|
|