[charlie66]

I'm modifying a Torker intake to make the 4 front runners wider, and while im in there im going to even out the stepped floor. So my question is do I go with the lower floor or the upper floor level? Its for a boosted engine. Originally I was going to lower the floor for more plenum size and port size , but then I started looking at the whole picture and the lower floor/runners go so flat from the plenum to the head flange where the higher floor/runners are high and have a nice pitch / slope downward to the flange . To me it seems the lower runners kind of fall off like a cliff as the air enters the head port, where the higher ones look like the air will enter in a more smoother flowing manner. Also if it was higher would it have better velocity and throttle manners?

Thanks ...