| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
09-20-2020, 11:34 PM
|
|||
|
|||
Trying to save a '64 GTO block
I have three blocks that look like they have been sleeved. Protrusions at the bottom of the case. One is a 69 400 block, two are 64 blocks, one of which codes out to a 64 4 speed GTO block.
I have a fourth block, a 66 421, that has the cylinders even with the bottom of the case. The questions are, 1) Has anyone heard of sleeving an entire block? 2) If the block has been sleeved, can it be re-sleeved back to standard bore? The 64 GTO block is already 0.030 over.
__________________
Inside of every small problem there is a big one struggling to get out..... |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode