| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
11-07-2020, 03:03 PM
|
|||
|
|||
Hydraulic Clutch Setup
Putting a TKO600 behind the 455 for my Catalina. I’m using the American Powertrain hydramax clutch set up. The issue is I do not have enough air space between the clutch fingers and TOB. I’m using a lakewood bell with a block plate. Tried two different flywheels and two different pressure plates. Even with .250 spacer between the bell and trans the most I can get is .065 air space. They recommend .150. I know this swap has been done plenty of times so surely someone else has had this problem. What am I doing wrong?
__________________
1979 TA 541/T56 Magnum 1964 Catalina 462/TKO600 1965 GTO 389/4speed |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode