 |
|
| THE LOBBY A gathering place. Introductions, sports, showin' off your ride, birthday-anniversary-milestone, achievements, family oriented humor. |
|
|
Thread Tools | Display Modes |
|
#1
12-25-2020, 12:36 AM
|
||||
|
||||
Pontiac motor on an s-10 frame?
I apologize ahead of time if I ave posted this before but that's one of the perks of being old. Instead of searching for a thread I may have made I can just start a new one.
Anyway, I recently purchased a 2001 s10 pickup with a 4.3 v6 and over drive transmission. The cab burned p but 99% of the wiring is still OK. The fuel pump is bad but the motor runs briefly when I pour a little gas into the Carb(? throttle body?) My plans are to shorten the frame 2"s and set my 39 Pontiac sedan on it. For the time being I will run the v6 but I want to eventually swap to Pontiac power. Does anybody here have any experience putting a Pontiac motor in an s10 and would one bolt to the s10 transmission? Lastly, MERRY CHRISTMAS to everyone!
__________________
Remember no one is perfect. Everyone's butt has a crack in it! |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode