[performerrpm]

my chassis guy kinda left me hanging so....im trynna do this myself. the car was already a ladder bar car but pretty cobbled up. so i had a new fab 9 built and then ordered all new trz 36 ladder bars and antiroll bar kit. with the car set at ride height and motor and trans set in it. the trans has a 3 degree drop, also the trans sits slightly higher than the rear at this ride height. right now ive got the pinion set with a 2 degree drop abd i get a 1.30 reading in the middle of the drive shaft.


what shoukd i be look for? everything ive read says 2 down on the pinion even one article said 1 degree for ladder bars