| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
10-27-2021, 04:41 PM
|
||||
|
||||
Connecting Rod Bearing Alignment
I have been installing the bearings in the rods and torqueing the caps preparing to measure oil clearance.
Sealed Power/FM Bearings and Eagle I-Beam Rods. '67 400 Block. The bearings seem to be misaligned even after being torqued. I have cleaned everything very well and have even tried moving the bearings to different rods to see if things changed, no real difference. 2nd picture shows it better. I don't think I'm doing anything wrong, is there any particular preparation that I may have overlooked? I don't think this would be a problem on the inside of the rods (where they face each other) but I'm concerned about rubbing the fillet on the outside of the rods. Any idea's or suggestions?
__________________
1967 Pontiac GTO 1965 Olds Cutlass 2014 Ford Mustang ----------------------------------- GTO-The Great One for 1967 ----------------------------------- |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode