FAQ |
Members List |
Social Groups |
Calendar |
Search |
Today's Posts |
#1
|
|||
|
|||
![]()
I have an 80 pace car Trans Am
I pulled the dash cluster to replace the clock with a turbo boost gauge from TTA Performance. By the way (Joe) one of the most knowledgeable on the Turbo TA out there. There is a fiberoptic small cable / that has a small metal z clip attached / that plugs into the back of the cluster but I can't remember where it plugs in to. The cable length is not that long so it is limited as to where it goes. I put in a small hole, on the right facing the cluster installed with an existing twist bulb socket holding the z bracket in place Any help would be greatly appreciated I can send a picture if this would help THANKS AGAIN |
|
|