[PDC]

I’ve got a project underway that requires a pair of wires spliced into a single female spade connector like this:

https://www.americanautowire.com/sho...25-term-10-pcs

Of course, American auto wire sells a Crimper specifically designed to do a pair of side-by-side roll crimps for this very connector - provided you don’t mind dropping $85.00:

https://www.americanautowire.com/sho...lice-clip-6746

Since this is likely the only time I will ever need to secure this type of 2-to-1 connection, I hate dropping that dough on a tool I will use only once. Any tips on completing a nice crimp on this 2-to-1 connector without the special tool?

Thank you!