05-26-2022, 06:38 PM

76TA462

Senior Chief

Join Date: Oct 2015

Posts: 350

brake pressure switch

I have been using a Wilwood Master Cylinder with the Combination Proportioning Valve for a few years now. The OEM wire for the brake pressure switch is a single wire with a simple plug at the end. The Wilwood switch has two contacts so I just tucked the OEM wire to the side and use the rubber boot with the Wilwood kit to hide the two prongs. I haven't had an issue with it as is, but for completeness I am thinking of connecting the wire. Does anyone know if there is a way to make this work with the OEM single wire. Thanks.

Reply With Quote

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 02:03 AM.

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

Menu

About Us