| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#27
07-14-2022, 11:11 AM
|
||||
|
||||
Look at post #17 again. If the accelerator pump feed hole were at the top (rotated 90 degrees), a long slot would be at the 9:00
position and a smaller slot would be at the 4:00 position. A drill make makes a circular pattern. In post #17 you can clearly see a rectangular slot cut into the metal and another smaller slot on the opposite side. Tom V.
__________________
"Engineers do stuff for reasons" Tom Vaught Despite small distractions, there are those who will go Forward, Learning, Sharing Knowledge, Doing what they can to help others move forward. |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode