| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
06-29-2023, 12:49 PM
|
||||
|
||||
1963 transmission
Should the transmission be exactly centered in the frame?
Trying to fit a new crossmember for my Richmond 5 speed but noticed that the center of the output shaft is 1 1/2” (3/4” off center) closer to the drivers side. The engine mounts are not completely tightened down but they do locate the position of the mock up engine very well. I tried to pry the trans over but it doesn’t really want to move. I don’t want to fab an off center crossmember and then have an issue. Engine mounts are new, not sagging old ones.
__________________
" Darksiders Rule "
|
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode