[GTOh!]

Hello all. I’m in the process of removing my WV code engine to replace rear main seal and doing some detail work on engine and engine bay. I was unable to get the starter off the engine without first removing the LH exhaust manifold. It was an absolute bear. The length of the starter assembly would not allow me to move it forward and tilt down. The nose would not clear the bell housing before the front end hit the frame crossmember. Once I removed the manifold and got the starter out, I noticed it’s not the original starter. Looks like it’s from a Camaro. I suspect the aluminum nose is too long/incorrect for the car.

I’m hoping that someone here can/will measure overall length of the correct starter. I think the original part is GM 1108335(?)

Thanks!
Don