 |
|
| THE LOBBY A gathering place. Introductions, sports, showin' off your ride, birthday-anniversary-milestone, achievements, family oriented humor. |
|
|
Thread Tools | Display Modes |
|
#1
05-18-2024, 09:07 AM
|
||||
|
||||
SBC pushrods not spinning
On the 77 MC observed while diagnosing a miss at idle and a bog during initial light power takeoff. I'm assuming the cam is wiped. All I hear/ read about is how new cams are disintegrating left and right. Was told to "put in a roller". I'm like bull**** this is a passenger car cast pistons low compression 4800 revs max.
I'm willing to up the specs on a replacement a wee little bit but I do not want "camshaft failure" after replacing it due to "soft metal ". Any ideas on a good flat tappet? 350 2 jet all original.
__________________
Hecho en China is not good for U.S. |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode