| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
08-23-2024, 02:08 PM
|
|||
|
|||
'63 V8 Conversion - Need Measurements
Hello - I am converting my 4-cylinder Tempest to a Pontiac V8. I'm not using a factory crossmember, so I need to fabricate the engine mounts. I'm hoping someone can provide some measurements to help position the engine. Specifically, I'd like to know the distance from the rear bellhousing flange to the firewall. Also, any measurements showing height of the block would be very helpful as well. Please see the attached picture showing where the measurement is taken from.
Thanks in advance! Tom Kuhn
__________________
Hoping to finish a project while I'm still able to push the clutch in....  1963 Tempest Convertible (Ram Air IV w/4” stroke), TKX, 9-inch w/3.70 gears and triangulated 4-link) Pictures |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode