[propuckstopper]

Hi guys. I am just putting the finishing touches on the restoration of my 1965 GTO console (4 speed car). The car left the factory with this console, but when it was restored some years back it was not re-installed. When I bought the car about 12 years ago, this console was in the trunk in a box and was neatly packaged.

So, I have not even raised the carpet yet to have a look, but I am wondering if there exists some type of factory literature out there that illustrates the proper measurements for install at the factory in 1965.

I realize I might have to just wing this install completely, and I am thinking it really won't be all that difficult. However, it would be great to have some sort of factory diagram with measurements, so I can compare my journey with how it was done at the factory.

I do have everything(I think) as far as brackets and screws are concerned. Ames was helpful on the few parts I needed.

Thanks!