[performerrpm]

so i picked up a couple motors over the weekend, one being a 71 yc 455.

its standard bore, been vatted, cam bearing installed, honed, new rings and bearings. it came with a rebuilt set of 6x8 heads the bracket master 2 cam i have in the sales section. stock cast pistons reused/rods.

i have 2 options, take it apart and check everything and put back together just to complete it. maybe shave .030 on intake and deck side of the 6x's and possibly use the bm2 cam


or i have 428 crank 20/10...eagle h beams, and a set of 4.150 428 icons i could put in..at that point i dont know that the 6x8s would be a good fit but a helluva short block.

i was trying to get rid of all this pontiac stuff, and now in 2 weeks ive aquired, 1 400 long block, 428 4bolt block, bare 400 block, and 1 455.